It should be attached to the pressure switch on a small air fitting. Remove these screws and the panel should lift up slightly, then come off, exposing the components behind it. At the bottom edge on each side of the operator panel is a small screw. Remove the cover plate under the panel by removing the series of screws holding it in place. Remove the small panel that is angled above the washer lid and just below the operator panel. There are still dangerous voltages behind the front panel with the unit shut off. On your model washer, the switch will be located behind the load level selector knob behind the front panel. This may save you from having to purchase a new switch.
5911 Answers SOURCE: Have you checked the pressure switch to ensure the rubber air hose is still attached? It is common for the air hose to come loose, or develop a small hole or crack and give the same symptoms.DONT pull the tube out of the drum or you could have a leak, that 's why I said GENTLY. All washing machines have a pressure switch, it is a rubber tube leading into the outer drum and up to the switch, located up on the frame top rail under the lid, if this tube becomes blocked with dried detergent suds it wont function, gently pull of the rubber tube from the switch and suck and blow through if you can or push a piece of flexible electric wire through it then blow it again and reconnect and test. Craftsman 5 Hp Shredder Manual on this page.
0 kommentar(er)
